The Nokia EOS has a mechanical shutter for the camera, just like the Nokia 808 Pureview, but while we are sure it is essential to the design we really had no idea why it was better to have than not to have it.
In a comment on MyNokiaBlog ex-Nokian Damian Dinning, who was the head of their imaging department until last year, explains that it is all about the Xenon flash.
Hi everyone, there are so few factually correct statements in the original piece or related comments (no disrespect intended) I felt compelled to help explain.
Please note, my comments are ONLY addressing the general topic of mechanical shutters – no more.
Keeping it simple, the main reason for fitting mechanical shutters is for use with xenon flash. Typically CMOS sensors read light across the sensor from left to right and top to bottom. The time each pixel is ‘read’ is the effective shutter speed. This is OK in most cases and OK with LED flash as the light is effectively constant/continuous. LED flash in most cases being the equivalent of turning on a torch before the exposure and turning it off after the exposure has been made, effectively increasing the amount of light in the scene more or less for the duration of the picture.
In the case of xenon, the flash fires a very short ‘pulse’ of light. This pulse can be as short as approximately 1/25,000 (hence why xenon can freeze high speed movement). With a typical CMOS sensor the time difference between the 1st pixel being ‘read’ and the last is greater than this time. The result would be some pixels would be correctly exposed whilst others would be dark or even potentially black. To overcome this, the pixels are effectively read all at the same time. But to achieve this all pixels are turned on, the shutter opens, the flash fires, the shutter closes and the pixels turned off. And that’s why typically mechanical shutters have been needed in products such as n8, n82, n808. In some cases some latest generation sensors can read all their pixels at very high speed (note: again don’t ask me to comment on speculation or rumour) allowing xenon to be used. In some cases e.g. Nikon 1 series these later generation sensors are allowing for electronic shutters which can provide potential advantages in high frame rate scenarios which mechanical shutters would not be suitable for.
In some cases a hybrid approach maybe used e.g. a SE product of a few years back which featured xenon only used the mechanical shutter for flash but not other situations, which meant in that case it didn’t provide the following potential advantage….
With mechanical shutters, because the pixels are effectively read all at the same time it overcomes the motion skew effect which can typically occur with CMOS sensors due to the time difference between the first and last pixels being read. As the read time from CMOS sensors is increasing (shorter read times) this is becoming less of an issue in some cases.
Mechanical shutters do require additional space, there are no space advantages to them.
As for dust protection there is some theoretical advantage to them but in practice (at least in my experience) I have seen dust penetration in all cameras, there is a fundamental limit to what can be done to prevent dust penetration.
Hope that clarifies things.
So in short, its all about being able able to get evenly exposed pictures which are able to freeze a moment in time, and should be great for action photography.